Edge-Core ES4612 - Boot System

Flash/File Commands
4-69
4
boot system
This command specifies the file or image used to start up the system.
Syntax
boot system {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom - Boot ROM.
• config - Configuration file.
• opcode - Run-time operation code.
The colon (:) is required.
filename - Name of the configuration file or image name.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (4-67)
whichboot (4-68)
Console(config)#boot system config: startup
Console(config)#