Edgewater Networks 4200 Series - Getting Started with the 4200; Physical Installation and Initial Connection

4200 User Manual Edgewater Networks, Inc.
Version 3.0 11
Chapter 2: Getting Started
Physical Installation
The 4200 is designed for either desktop or wall mount installation. Please
observe the following guidelines when installing the system:
 Never assume that the AC cord is disconnected from a power source.
Always check first.
 Never place objects greater than 5 lbs on top of the 4200 as damage
to the chassis may result.
 Always connect the AC power cord to a properly grounded AC outlet to
avoid damage to the system or injury.
 Ensure that the physical location of the installation has adequate air
circulation and meets the minimum operating conditions as provided in
the environmental specifications for the system. These can be found
on our website at
www.edgewaternetworks.com.
Desktop Installation
A. Remove the 4200 and accessories from the shipping container.
B. Place the 4200 on a flat, dry surface such as a desktop, shelf or tray.
C. Connect the power and network cables to the appropriate ports on the back of
the system.
Wall-Mount Installation
The 4200 can be wall-mounted using the two mounting brackets on the bottom of
the appliance. We recommend using two round or pan head screws.
A. Install two screws 5 14/16
”
horizontally apart on a wall or other
vertical surface. The screws should protrude from the wall so that you
can fit the appliance between the head of the screw and the wall.
B. If you install the screws in drywall use hollow wall anchors to ensure
that the unit does not pull from the wall due to prolonged strain from
the cable and power connectors.
C. Remove the 4200 and accessories from the shipping container.
D. Hang the 4200 on the wall.
E. Connect the power and network cables to the appropriate ports on the
back of the system.
 WARNING: Secure the power supply using a fastener or nearby shelf
so that it does not hang from the power connector.