Edgewater Networks 4200 Series - Static IP Routing

4200 User Manual Edgewater Networks, Inc.
Version 3.0 79
Delete a Static NAT entry
A. Select NAT.
B. To delete an IP address or a range of IP addresses highlight the entry in the
Static NAT Client Entries list and press the Delete key on your keyboard.
C. Press Submit.
Static IP routing
In addition to locally connected IP networks the 4200 can forward traffic for one
remote data network by configuring a static route entry. Any packets destined for
the remote data network will be forwarded to the specified gateway address in the
entry.
Configure the static route
A. Select System.
B. Select Route.
C. Select the
Apply Route
checkbox.
D. Enter the IP
Network
address. This
address is the
remote data
network you
would like the
4200 to
forward to the
gateway. The
hosts portion of the IP address should be set to “0”. For example,
192.168.4.0
E. Enter the Netmask of the remote data network. For example, 255.255.255.0
F. Enter the Gateway IP address of the interface that will receive all packets
destined for the remote data network.
G. Press Submit.