4200 User Manual Edgewater Networks, Inc.
Version 3.0 9
connected to IP phones, IADs or PCs installed on the local area network (also
known as the private network).
WAN Ethernet port
The WAN Ethernet port is a 10/100 auto sensing port that should be
connected to the wide area network (also known as the public network)
through a WAN termination device such as an xDSL modem or router
Erase Switch (newer hardware will say “Reset” see below for switch
details)
To erase any custom configuration and restore the 4200 to its factory default
state depress the erase button once, wait for the LEDs to illuminate and press
again before 2 seconds expires.
WARNING: Using the Erase switch as outlined above means any
configuration made to the 4200 will be lost. Additionally the VoIP
ALG registration code must be re-entered in the 4200 as covered in
Chapter 4: System Diagnostics, viewing the ALG registration code.
Erasing the configuration means that IP phones installed behind the
4200 will not work and Internet connectivity or network access for
PCs will be down until the system is reconfigured.
Reset Switch
To perform a “soft” boot depress the reset button once, to erase the CLI
password and set it back to the factory default CLI password depress the
reset button twice, to erase any custom configuration and restore the 4200 to
its factory default state depress the reset button three times.
WARNING: Using the Erase switch as outlined above means any
configuration made to the 4200 will be lost. Additionally the VoIP
ALG registration code must be re-entered in the 4200 as covered in
Chapter 4: System Diagnostics, viewing the ALG registration code.
Erasing the configuration means that IP phones installed behind the
4200 will not work and Internet connectivity or network access for
PCs will be down until the system is reconfigured.
To Next Page
Loading...
