4200 User Manual Edgewater Networks, Inc.
Version 3.0 98
Chapter 7: Upgrading the 4200
This chapter describes how to upgrade your 4200 to the latest software release
available from Edgewater Networks. Information on the latest release can be found
in the release notes section of our website at:
http://www.edgewaternetworks.com/Support/SupportDocLanding.html#ReleaseNote
s
It is recommended that you reboot the 4200 prior to performing the upgrade. This is
to make sure there is enough dynamic memory available to handle the upgrade
process.
WARNING: When you update your software telephone services will
be unavailable for several minutes. It is therefore advised that
upgrades be performed during a maintenance window when
telephone traffic can be interrupted.
Upgrade Procedure for Software Revision 1.3.11 or Later
Use this procedure if your 4200 is running software revision 1.3.11 or later. The
software version can be found on the System page of the web GUI.
A. Select System.
B. Select Upgrade
firmware.
C. Enter the
Download
Server IP
address of
204.202.2.188
is the public IP
address of the
FTP site hosted
by Edgewater
Networks.
D. Enter the Filename: image.bin
E. Press Submit.
You can follow the progress of the upgrade by selecting the refresh the upgrade
status link.
WARNING: Do not change the configuration or power off the device
until the write is 100 percent complete. The 4200 may become
unusable if the write is interrupted. The flash write can take up to 5
minutes depending on the speed of the download server.
To Next Page
Loading...
