4200 User Manual Edgewater Networks, Inc.
Version 3.0 54
Example of user commands:
ifconfig eth0:20 192.168.20.10 netmask 255.255.255.0
iptables -I POSTROUTING -t nat -s 192.168.20.10 -j ACCEPT
⇒
Select Submit
Networking Restart
Use Network Restart to stop and the restart all the networking services that
are running on the system. Technical support may request that networking
services be restarted during a troubleshooting session.
⇒
Select System --
Select Network Restart --
Restarting network services will interrupt the system for up to a
minute. All voice, video and data sessions currently in progress
will be interrupted! Proceed with caution!
⇒
Select Restart
Reboot System
Rebooting the system stops all networking services and reboots the system.
The operating system and networking services will be loaded from scratch.
Reboot is functionally equivalent to power cycling the system. Technical
support may request that the system be rebooted during a troubleshooting
session.
⇒
Select System --
Select Reboot System --
Rebooting the system will interrupt services for a few minutes.
All voice, video and data sessions currently in progress will be
interrupted! Proceed with caution!
Select Reboot
To Next Page
Loading...
