4200 User Manual Edgewater Networks, Inc.
Version 3.0 47
Services Configuration
The Services Configuration page allow the user to configure the services that
are running directly on the system. These services include the web server,
telnet server, SSH server, syslog and SNMP daemons.
⇒
Select System --
Select Services Configuration --
Customize the
configuration of the services accessible on the System.
o Enable SNMPv1 --
Check this box to enable SNMPv1.
o SNMPv1 Read only Community --
SNMPv1 Read-Only
Community: The community string that the management station uses
when accessing read-only objects from the system. The default is
'public'.
o SNMPv1 Trap Community --
Trap community string place in trap
pdus.
o Enable SNMPv3 --
Check this box to enable SNMPv3.
o SNMPv3 User Name --
If SNMPv3 is enabled, this field defines the
SNMPv3 user name for SNMPv3 USM based authentication and VACm
access control.
o SNMPv3 Passphrase --
The SNMPv3 passphrase is optionally used
to authenticate the user as well as encrypt the payload based on the
SNMPv3 Security setting below. The minimum length of a valid
passphrase is 8.
o SNMPv3 Security --
The SNMPv3 security level for user
authentication and encryption of both synchronous requests as well as
asynchronous traps. "None" means neither SNMPv3 authentication or
encryption are used. "Auth(MD5)" means authenticating user using
MD5 hash algorithm. "AuthPriv(MD5/DES)" means authentication as
well as encryption using the DES encryption algorithm. The default
value is None.
☞
None
☞
Auth(MD5)
☞
Auth(MD5/DES)
o SNMPv3 Trap Context --
The SNMPv3 trap context defaults to
nothing but can be set to any string.
o SMNP Common Configuration
o System Location --
A comment string that can be used to indicate
the location of the system. By default, no value is set.
To Next Page
Loading...
