Edgewater Networks 4200 Series - System

4200 User Manual Edgewater Networks, Inc.
Version 3.0 31
☞ Maximum Number of Call Allowed --

 Enter the total
amount of VoIP calls allowed to traverse the system e.g. RTP
streams from VoIP devices. Use CAC to ensure the system will NOT
over subscribe the total amount of WAN bandwidth. If the codec is
G.711, then the required data rate per call is 85.6 Kbytes/sec. If
the codec is G.729, then the required data rate per call is 29.6
Kbytes/sec.
⇒ Select Submit
System
The most commonly accessed system information is presented on the system
page. The software version, hardware platform, and LAN MAC address are
common pieces of information requested by system administrators and
technical support.
The registration status for the ALG feature is displayed to ensure that the
feature is enable. If the feature is not registered, no calls will be allowed to
pass. The registration code is available on a sticker on the bottom of the
system or from your service provider.
The password for administrator web access is set on the Reset Password
page. The system administrator should reset the password when the system
is first installed. Changing the default password will increase the security of
the system.
⇒ Select System
o Software Version (view only) --

 This will display the current
running system firmware version.
o Hostname --

 Displays the currently assigned Hostname of the
system.
 Select System --

 Select Service Configuration to change the
Hostname of the system.
o Model Number (view only) --

 Displays the model number of the
system.
o LAN Interface MAC Address (view only) --

 Displays the LAN
interface MAC address of the system.
o Registration Status --

 The registration status for the ALG feature
is displayed to ensure that the feature is enable. If the feature is not
registered, no calls will be allowed to pass. The registration code is
available on a sticker on the bottom of the system or from your service
provider.