4200 User Manual Edgewater Networks, Inc.
Version 3.0 45
Set Link
Set Link displays the current Ethernet interface link settings for the system. If
needed, the rate for each interface can be set manually to establish a reliable
connection.
Note; When the link rate is set manually, ensure that the
device at the far end of the connection can communicate at the
desired rate. Incompatible rates can cause a loss of
communication with the system.
o Link Rate Settings --
Displays the current settings for the LAN and
WAN interfaces. The default setting is auto negotiate.
LAN 1 Ethernet --
When the value is changed the system will
apply the settings, caution you may loose connectivity to the
system if the value is not correct on both sides of the link.
☞
Autonegotiate
☞
10BaseT-HD (Half Duplex)
☞
10BaseT-FD (Full Duplex)
☞
100BaseT-HD (Half Duplex)
☞
100BaseT-FD (Full Duplex)
LAN 2 Ethernet --
When the value is changed the system will
apply the settings, caution you may loose connectivity to the
system if the value is not correct on both sides of the link.
☞
Autonegotiate
☞
10BaseT-HD (Half Duplex)
☞
10BaseT-FD (Full Duplex)
☞
100BaseT-HD (Half Duplex)
☞
100BaseT-FD (Full Duplex)
LAN 3 Ethernet --
When the value is changed the system will
apply the settings, caution you may loose connectivity to the
system if the value is not correct on both sides of the link.
☞
Autonegotiate
☞
10BaseT-HD (Half Duplex)
To Next Page
Loading...
