4200 User Manual Edgewater Networks, Inc.
Version 3.0 14
ADSL-PPPoE --
Select ADSL-PPPoE to enable the username
and password options
o User Name --
Enter the username given to you by your
network provider.
o Password --
Enter the password given to you by your
network provider.
o Keepalive Ping --
If Keepalive Ping is enabled, your
system will send an ICMP echo request to its gateway
approximately in 1 minute intervals to ensure that your ISP
keeps the PPPoP connection open.
o PPPoE Link Status (view only) --
This will display the
status of the PPPoE line “Up” or “Down”.
DHCP --
Select DHCP if you want to get WAN side IP address
using DHCP server available in WAN side of the network.
Note; To view the WAN IP address given to the system,
go to the Network Information page.
Static --
Select Static if you want to configure WAN interface
with a static IP address (default view).
o IP Address --
Enter the WAN IP address for the system.
o Subnet Mask --
Enter the Subnet Mask for the WAN IP
address.
o Default Gateway --
Enter the default IP gateway for the
system. This gateway will be on the same IP subnet as the IP
address.
o Primary DNS Server --
Enter the Primary DNS Server for
the system to resolve domain names to. This address should be
supplied by your ISP provider.
o Secondary DNS Server --
Enter the Secondary DNS
Server for backup in case the primary is not reachable. This
address should be supplied by your ISP provider.
⇒
Select Submit
To Next Page
Loading...
