III-3-2. Setup Wizard
You can run the setup wizard again to reconfigure the
basic settings of the device, or you can run a wizard to
help you switch the device to a different operating mode. Select “Setup
Wizard” or “Switch to Router/Access Point/Range Extender/Wireless
Bridge/WISP mode” and then click “Run Wizard” to begin.
This wizard will help you to set up the basic
functions and settings of the device. For
guidance about using the setup wizard, please
refer to II. Installation.
Switch to Router/Access
Point/ Range Extender/
Wireless Bridge/ WISP
mode
This wizard will help you to switch the device
to a different operating mode: Wi-Fi router
mode, access point mode, range extender,
wireless bridge, or WISP mode (see below).
Switch to Router/Access Point/ Range Extender/ Wireless Bridge/ WISP
mode:
1. Follow the on-screen instructions to back up your current settings and
then reset the device back to its factory default settings.
2. After the device has reset you will see the screen below. Close your
browser and open it again.
To Next Page
Loading...
Need help?
General
