III-4-4. LAN
You can configure your Local Area Network (LAN) on
this page. You can enable the router to dynamically
allocate IP addresses to your LAN clients, and you can
modify the IP address of the device. The device’s default IP address is
192.168.2.1.
You can access the browser based configuration interface using
the device’s IP address instead of using the URL
http://edimax.setup.
Specify the IP address here. This IP address
will be assigned to the EW-7208APC and will
replace the default IP address.
Specify a subnet mask. The default value is
255.255.255.0
Select “Enable” or “Disable” to enable/disable
802.1d Spanning Tree. This creates a tree of
connected layer-2 bridges (typically Ethernet
switches) within a mesh network, and
disables those links that are not part of the
tree, leaving a single active path between any
two network nodes.
Enable or disable the DHCP server.
Select a lease time for the DHCP leases here.
The DHCP client will obtain a new IP address
after the period expires.
Your device’s DHCP server automatically assigns IP addresses to computers on its
network, between a defined range of numbers.
To Next Page
Loading...
Need help?
General
