Edimax EW-7208APC User Manual

Subnet Mask
Input the subnet mask assigned by your ISP here.
Default Gateway
Address
Input the default gateway assigned by your ISP
here. Some ISPs may call this “Default Route”.
MAC Address
If your ISP filters access by MAC addresses, enter
your computer’s MAC address here. Click “Clone
MAC” to automatically enter your computer’s MAC
address.
DNS Address
Select “Obtain an IP address automatically” or “Use
the following IP address”. Check with your ISP if you
are unsure.
DNS Address 1,2 & 3
Enter the DNS address(es) assigned by your ISP
here.
Enable Dual-WAN
Access
Enable/disable dual WAN access. When you enable
dual WAN access, select an IGMP source and enter
a “Host Name” and “MAC Address”.
User ID
Input the user name assigned by your ISP here.
Password
Input the password assigned by your ISP here.
L2TP Gateway
Input the L2TP gateway assigned by your ISP here.
Connection ID
Specify a reference name/ID for the connection.
MTU
Enter the maximum transmission unit (MTU) value
of your network connection. The default value is
1392.
Connection Type
Specify a connection type:
1. “Continuous”: Connected all the time.
2. “Connect on Demand”: Connect when you
initiate an Internet connection.
3. “Manual”: Connect/disconnect manually using
the “Connect” and “Disconnect” buttons.
Idle Time Out
Specify the amount of time the router waits before
shutting down an idle connection. Only available
when “Connect on Demand” (above) is selected.

Edimax EW-7208APC Specifications

General

Brand	Edimax
Model	EW-7208APC
Category	Wireless Access Point
Language	English