84
The descriptions of every setting in this menu will be given below:
Item Description
Upgrade
Firmware
If you downloaded latest firmware file from our website,
you can click this button to start to upload the firmware
file to the IP camera, and you’ll be prompted to provide
the location of firmware file.
Click ‘Open’ to start uploading new firmware and IP
camera will start upgrading, please be patient. The IP
camera will reboot after the upgrade procedure is done.
Reset to Default Clear all settings in the camera. Please think again
before you do this, and then click this button to reset all
settings.
NOTE: IP address will be reset to default value
‘192.168.2.3’ also. You’ll need to change the IP address
setting of your computer if the IP address of your
computer does not begin with ‘192.168.2’, and subnet
mask is not ‘255.255.255.0’, or you’ll not be able to
connect to this IP camera again.
LED Light OFF Switch the LED light of this IP camera off, so ‘LAN’ and
‘WLAN’ LED on the IP camera will stop working, in case
you don’t want other people know the camera is
transferring data.
You can click this button again to switch LED lights on
again.
After all settings are completed, click ‘OK’ to save settings, or click ‘Cancel’ to abort
and discard changes.
To Next Page
Loading...
