EDISecure DCP 350 - Page 48

User Manual Page 48
EDIsecure
®
DCP 350
4.2.2 Select printer and control
When you execute CardPrinterTest, it will search connected printers by USB and Network automatically and
the EDIsecure
®
DCP 350 printer connected to USB has higher priority. Other printers could be selected by
pull-down menu. You can test all functions with connected printer.
Control is consisted by SBS (Step by Step), Move, Rotate, etc. section and you can control printer by each
step.
 SBS
SBS is to operate the EDIsecure
®
DCP 350 printer in SBS (Step-By-Step) mode which you can
control the printer using commands. In SBS mode, after printing data transmission, printing a card
will be run only by clicking “DoPrint”. It is the main difference between NORMAL mode and SBS
mode. When you click “Start”, the EDIsecure
®
DCP 350 is operated in SBS mode, and existing
spooled data will be eliminated. To exit SBS mode, click “Stop”.
 Card
Card is to bring a card into printer and eject a card. “In” is to move a card from input hopper to
printer and “Out” is to move a card from printer to output hopper. In case the flipper is installed,
“Back” ejects a card to the back side.
 Move
Move is to move a card to a specific position in the inside of printer. “Print” is to move a card to the
printing position, “Mag.” is to the magnetic encoding position, “IC” is to the contact smartcard
encoding position and “RF” is to the contactless smartcard encoding position. “To Rotator” is to
move a card from printer to flipper and “From Rotator” is to move a card from flipper to printer.
“from In” is to move a card from the card in sensor to where you define position, and “from Out” is
to move a card from the card out sensor to where you define position.
 Rotate
Rotator is to flip over a card in the printer installed flipper. “Auto” is to move a card from printer to
flipper and flip over a card and move a card to the printing position automatically. “Batch” is to
repeat “Auto” as many times as the number of set. “To Bottom” is to turn to the backside of card
and “To Top” is to turn to the front side of card.
 Etc
“Cleaning Roller” is to clean the roller by cleaning card automatically. “Use Log” is to display log in
message space.
4.2.3 Print
Please follow the steps given in this section.
1. Click “…” button and select a file.
2. Click “Open” button to prepare a file to print.
3.
Click “Print” Button to move print data to spool. In the NORMAL mode, Click “Print” button to print
a card, but in the SBS mode, “Print” button to transmit a printing data from PC to printer and wait
for printing. Therefore, you must click “DoPrint” to print in SBS mode. This function is for detail
control of printer.
4. Click “Close” button to close the file.