DCP 350
IC(PC/SC) : Contact Smartcard Encoding
The EDIsecure
®
DCP 350 printer supports the contact smartcard encoder in the printer inside and the SIM
encoder on the right of front side. “IC(PC/SC)” is to test a contact smartcard and SIM encoding.
“Batch” is applied only to the contact smartcard encoding because SIM encoder is installed outside and can’t
move a card automatically.
“ICH Contact” is to bring the encoder head into contact with the IC chip of smartcard physically.
“ICH Discontact” is to separate the encoder head from the IC chip of smartcard physically.
“Init” is to recognize and display the installed contact smartcard reader. The recognized encoder will be
displayed at the pull down control.
“Contact” is to contact with the smartcard electrically and initialize.
“Reset” is to finish the function electrically. After “Contact”, you can run “Get ATR”, “Read”, “Write” and
“Clear”.
“Get ATR” is to read the ATR data.
“Read” and “Write” are to read and write the defined data (Name, Address and Phone). These could not be
applied to all cards.
“Clear” is to clear the displayed data (ATR, Name, Address and Phone).
In case the data is read and written using APDU, Read/Write can be done by APDU commands.
“Load APDU” is to read the stored APDU commands.
“Save APDU” is to save the displayed APDU commands.
“Clear APDU” is to clear the APDU section.
“Send APDU” is to run the APDU commands.
Batch process repeats the following steps sequentially, Card “IN” Move “IC” IC “ICH Contact” IC
“Init” IC “Contact” IC “Write” IC “Clear” IC “Read” IC “Reset” IC “ICH Dis-contact”
Card “OUT”.
Pic.83 Contact smartcard encoding
To Next Page
Loading...
