Edwards RV3 Instruction Manual

9.4.10 Oil drain-extension
Fit the oil drain-extension between the oil drain port on the pump and the oil drain-plug
to make the drainage of oil from the pump easier.
9.4.11 Exhaust nozzle kit
The exhaust nozzle replaces the outlet ange. Use the exhaust nozzle to connect the
pump outlet to 12 mm internal diameter plasc hose.
9.4.12 Vibraon isolators
Vibraon isolators reduce vibraon and noise when the pump is oor or frame mounted
and help to reduce strain when the mounng area is uneven.
9.4.13 Solenoid operated gas-ballast valve
Fit the gas-ballast valve in place of the built-in gas-ballast control on the pump; the gas-
ballast adaptor (see Gas-ballast adaptor on page 53) must be ed with the solenoid
operated gas-ballast valve. The valve provides automac on/o control of the gas-ballast
and isolates the gas-ballast inlet when the pump is switched o.
9.4.14 Solenoid operated pipeline valve
Fit the pipeline valve between the vacuum system and the pump-inlet to provide
addional system protecon when the pump is switched o.
03/2021 - ©Edwards Limited
Page 54A65201880_AA
A65201880_AA - Service and spares

Edwards RV3 Specifications

General

Brand	Edwards
Model	RV3
Category	Water Pump
Language	English