STP-301/451 Series Instruction Manual
2
◇ The STP pump is provided with a high-speed rotor. Secure the STP pump according to the
specified method. Failure to do so may lead to serious personal injury, product and/or
peripheral equipment damage if any abnormality/error occurs in the rotor.
◇ The STP pump operates at high temperatures while the baking heater is in operation.
NEVER touch the STP pump and its peripheral equipment while the baking heater is in
operation.
Operators can burn hands.
◇ Execute the following to prevent an accident caused by the gas.
• Check the properties of the gas to be used, referring to the Material Safety Data Sheet
(MSDS) you obtain from the gas supplier. (explosive・combustible・toxic・corrosive, etc)
And, keep MSDS and a safety advice of gas supplier.
• Warn of the danger of the gas with the warning label when the use gas is hazardous
chemicals materials.
• Always execute gas purge in the pump with the inert gas, and then exhaust residual
gases thoroughly from the STP pump when removing the STP pump from the vacuum
equipment.
• Secure safety by wearing personal protective equipment when using the gas which
might influence damage health. In addition, take appropriate measure for depending
upon the properties of the gas to be used.
◇ Exhaust residual gas thoroughly when disposing of the STP pump. If the STP pump is used
for any toxic or reactive gas, always clean the STP pump and dispose of it as industrial
waste in accordance with guidelines given by the national and/or local government. Residual
gas in the STP pump may cause an accident which, for certain gases, may involve serious
injury or death.
To Next Page
Loading...
Need help?
General
