STP-301/451 Series Instruction Manual
4
STP-301/451
Series
◇ Use the STP connection cable that has a label affixed
The use of different cables may result in product damage.
◇ Connect the cables securely. NEVER bend nor place heavy objects on the cable. Doing so
may result in electric shock or product damage.
◇ NEVER remove the splinter shield from the STP pump. Doing so may result in product
damage.
◇ DO NOT put foreign objects into the STP pump. Doing so may result in product damage.
◇ Always use the power voltage specified on the nameplate for the primary power voltage of
the STP control unit. Wire the power cable securely. Incorrect wiring may result in electric
shock or product damage.
◇ The wipes used for clean the flange of the pump might become hazardous waste depending
upon the solvent (alcohol). Dispose of the contaminated wipes appropriately according to the
regulations of each national and/or local government.
◇ NEVER turn OFF the primary power (DO NOT switch the breaker "OFF") while the STP
pump is rotating. Doing so may result in product damage.
◇ Perform investigations into probable causes and remove them before restarting the STP
pump in the event of the occurrence of a problem. The use of the abnormal STP pump may
result in product damage.
◇ DO NOT move the STP pump and the STP control unit while the STP pump is in operation.
Doing so may result in product damage.
To Next Page
Loading...
Need help?
General
