STP-301/451 Series Instruction Manual
4-7
Installation
4.3.2 STP Pump Installation Positions
The STP pump can be installed vertically, horizontally, and upside-down and slanted.
Vacuum
Equipment
Upside-down
Horizontal
Slanted
Vertical
Figure 4.3 STP Pump Installation Positions
When installing the STP pump in a horizontal or slanted position, it is recommended to
install it so that the direction of the outlet port is on a vertical or horizontal plane in the
direction of the gravity.
This makes it possible to reduce the load on the magnetic bearing and the heat generated by
the STP pump.
Outlet Port
Outlet Port
Outlet Port
Outlet Port
Direction of Gravity
Figure 4.4 Positions of the Outlet Port on the Horizontally or Slanted Installed STP Pump
To Next Page
Loading...
Need help?
General
