Edwards STP-L301 Series

STP-L301/L451 Series Instruction Manual
12
TABLES
Table 3.1 Accessories.............................................................................................................3-1
Table 3.2 Accessories for Chemical Specific Pump (Type C).................................................3-1
Table 4.1 Tightening Torque of Bolt........................................................................................4-8
Table 4.2 Maximum Torque Predicted and Recommended Securing Bolt for Inlet Port Flange
................................................................................................................................4-9
Table 4.3 Number of Claw Clamps by Size of Flange...........................................................4-10
Table 6.1 Connecting the Power Cable.................................................................................6-13
Table 7.1 Starting/Stopping the STP Pump during Remote Operation (I/O TB2)....................7-5
Table 7.2 Reset Operation during Remote Operation (I/O TB2) .............................................7-6
Table 7.3 Starting/Stopping the STP Pump during Remote Operation (CON4) ......................7-7
Table 7.4 Reset Operation during Remote Operation (CON4)................................................7-8
Table 8.1 I/O TB1 Terminal Block ...........................................................................................8-1
Table 8.2 Rated Contacts for Relays CR1, 3, 5, 7, and 8 .......................................................8-4
Table 8.3 Rated Contacts for Relays CR5 and 6 ....................................................................8-4
Table 8.4 I/O TB2 Terminal Block ...........................................................................................8-5
Table 8.5 CON4 Connector (Remote Input Signal).................................................................8-7
Table 8.6 Rated Coils for Relays CR1, 2 and 3 ......................................................................8-8
Table 8.7 CON 4 Connector (Remote output signal)...............................................................8-9
Table 8.8 Rated Contacts for Relays CR4, 5, 6, 7, 8, 9 and 10 ............................................8-11
Table 8.9 Remote Cable Connections (Single-Side Connector Type) ..................................8-11
Table 10.1 States of LEDs and REMOTE Output Signals at Power Failure ...........................10-2
Table 10.2 Operations of the STP Pump after Power Recovery .............................................10-2
Table 10.3 Safety Functions ...................................................................................................10-4
Table 11.1 Error Messages.....................................................................................................11-3
Table 11.2 Troubleshooting after Powering ON ......................................................................11-7
Table 11.3 Troubleshooting when Performing the STP Pump Start Operation .......................11-7
Table 11.4 Troubleshooting while the STP Pump is Rotating .................................................11-8
Table 11.5 Recommended Spare Parts ................................................................................11-10
Table 11.6 Cleaning and Decontamination ...........................................................................11-11
Table 13.1 Specifications of the STP Pump............................................................................13-1
Table 13.2 Specifications of the STP Control Unit ..................................................................13-5