19Service Guide: EFI Fiery Central integrated server
Replacing parts
Avvertenza: Il server di stampa non deve essere mai sollevato afferrandolo dal pannello superiore, in quanto
quest'ultimo non può sostenere il peso dell'intero sistema.
Warnung: Heben Sie den Druckserver nicht an der oberen Gehäuseabdeckung an. Die obere Gehäuseabdeckung ist
nicht dafür ausgelegt, das Gesamtgewicht des Systems zu tragen.
Advertencia: No levante nunca el servidor de impresión agarrándolo por el panel superior. El panel superior no
soporta el peso del sistema.
Aviso: Nunca erga o servidor de impressão pelo painel superior. O painel superior não suporta o peso do sistema.
Waarschuwing:
Til de afdrukserver nooit op door het bovenpaneel vast te nemen. Het bovenpaneel kan het gewicht
van het systeem niet dragen.
To open the FC integrated server
1 Shut down the FC integrated server (see page 18).
2 Remove all cables from the back of the FC integrated server.
3 Remove the FC integrated server from the furniture if necessary (see page 77).
4 Remove all panels necessary to access the component that you need to service.
For guidelines on which panels to remove, see the service procedure for the component that you want to access.
Note: When removing multiple panels from the FC integrated server, use the following order:
• Left panel (see page 19)
• Right panel (see page 19)
• Front panel (see page 20)
• Top panel (see page 21)
Note: When replacing panels, reverse the order.
5 Place the FC integrated server on a flat surface. Attach an ESD wrist strap before handling internal parts (see
page 8).
6 Carefully position the FC integrated server so that it is resting on its side and the internal components are facing
up.
Place removed components on a grounded, antistatic surface.
To remove and replace the left or right panel
1 Remove the screws that secure the panel to the back of the chassis.
Set aside the screws so that you can replace them later.
To Next Page
Loading...
Need help?
General
