74Service Guide: EFI Fiery Central integrated server
Troubleshooting
Network (continued)
System starts up slowly
then displays one or
more DHCP error
messages on the control
panel.
Possibly one of the following:
• Network cable is connected to the
wrong RJ-45 port
• No cable/wrong type of cable is
connected to the network port
• Network cable or connection is
faulty
• Network is faulty
• System searches for a nonexistent
DHCP server because DHCP is
enabled by default on the FC
integrated server, but the
customer’s network is not using
DHCP
• Ethernet interface on the FC
integrated server motherboard
is faulty
• System software is corrupted
1 If the problem persists, ask the network administrator
to check Network Setup. To configure a static IP
address (if applicable for the customer site, as in a non-
DHCP environment), work with the network
administrator as described in the Configure Help.
2 If the problem persists, ask the network administrator
to check other devices on the network.
If other devices are not functioning, the problem may
be with the network.
3 If the problem persists, reinstall system software
(see page 55).
Corrupt system software may cause the system to hang.
4 If the rest of the network is functioning properly
and the problem persists, replace the motherboard (see
page 30).
Table 2: FC integrated server error messages and condition (Continued)
Symptom Possible cause Suggested action
To Next Page
Loading...
Need help?
General
