Eizo ColorEdge CX271 - 4-2. Executing SelfCorrection

34
Chapter4SelfCorrection
●
Setting SelfCorrection Schedule
After executing SelfCorrection or monitor adjustment using software (ColorNavigator or ColorNavigator
Elements), set when to execute the next SelfCorrection.
Setting Range
50 hours to 500 hours (Recommended: 200 hours)
Procedure
1. Choose “SelfCorrection” from the Adjustment menu, and press
.
2. Choose “Schedule” from “SelfCorrection”, and press
.
3. Choose “Interval” from “Schedule”, and press
.
4. Select Interval with
or , and press .
5. Press
to exit.
Note
• SelfCorrection can also be executed when there are no computer signals being input.
4-2. Executing SelfCorrection
SelfCorrection can be executed manually regardless of the schedule.
Procedure
1. Choose “SelfCorrection” from the Adjustment menu, and press
.
2. Choose “Execute” from “SelfCorrection”, and press
.
The built-in correction sensor is activated, and SelfCorrection is executed.
Attention
• After selecting “Execute”, aging may be executed before the built-in correction sensor is executed.