(
r
(
Start-Up
and
Adjustments
Copyright Notice
At the upper right area of the Status page is the copyright notice.
If
an
error occurs, the copyright notice is
replaced with the fault information described below.
Fault Information
While the BRU-Series drive
is
powering up, diagnostic checks are run
to
check for proper operation
of
the
drive. Also, while the BRU-Series drive
is
operating, the drive is monitored for fault conditions. If a fault
occurs at either time; then the drive is disabled; the red LEOs display the fault code, and a fault message
is
displayed in the upper right side of the Status page. The fault message includes a description
of
the fault,
some probable causes for the fault, and some possible remedies. Refer
to
Section 6.3
for
a list
of
the fault
messages.
Help Information
At
the lower right area of the Status page are
two
lines which list available keys while in the Status page.
They are
as
follows:
< P > - page command. Turn
to
Setup page.
< ESC> -refresh the Status Screen.
5.2.3.2.3 Setup Page
The Setup Page is used
to
modify the BRU-Series drive setup parameters for the specific application. The
first 6 lines contain
two
columns
of
variables. The last 2 lines provide information about the variable the
cursor
is
beside. The only cursor movement available is
up
or
down.
To
move the cursor
to
variables
in
the right column, press the 'cursor
up
', < U
>,
or 'cursor down', < Enter
>,
keys. The cursor moves
.downj
up
one column then moves downj up the next column when pressing the <
Ente
r>
1 < U > key. Note
that the
up
arrow and down arrow keys will produce this cursor movement on some terminals. Refer
to
Appendix B
for
a list
of
the codes used
by
the BRU-Series drives.
GAIN
GAIN
399.9
RPM
/
VI
p
0.
0000
v I I
2
4.8
AMP
0 GAIN
4599
RPM
II
Mode ( 7) :
ScaLe
Offset
Peak
I
Over
s
peed
FiLte
r
BW
300
Hz
Mon i
tor-
I
I
700
20
0
Ve L
oc
it
!:j
Torq
U-Cursor
Up,
P-Ne
x t
Page,
<
ENTER>
-C
ursor
Do
wn
R-
Reset
S
etup,
5-Sa
ve Se
tup
Figure 5-7 Serial Terminal SETUP PAGE (Velocity Mode}
BRU-200/ BRU-500
Bru
s
hf
ess
Dr
ives I
ns
tru
ct
ion
Manu
al
31
To Next Page
Loading...