Elma Elmasonic Select - Operating Modes; Setup and Connection; Installation Site Requirements

9 Set up and connect the unit Elma Schmidbauer GmbH
18 / 32 Elmasonic Select
8.3 Operating modes
Operating mode Brief description Display
Switched off
The unit is being supplied with power
and is switched off.
Off
Standby
The unit is switched on. The display is
dimmed after a longer period of
inactivity. The automatic safety shut-off
is activated after 8hours of inactivity.
On
Setup
The unit is switched off. The Setup
menu is activated to change the unit
functions.
• Setup symbol
• Number of the selected unit function
(parameter)
• Current setting (parameter value)
Normal
mode
The unit is ready to use. Ultrasonic
cleaning can be conducted using
adjustable operating parameters.
• Set operating parameters
During Normal mode:
• Current operating status
Programme
mode
The unit is ready to use. Fourstored
programmes can be selected for
ultrasonic cleaning. The programmes
can be specified and saved.
• Available programmes
• Operating parameters of the selected
programme
No programmes have been saved:
• Programme number1 and "--" for
duration and temperature
During programme operation:
• Current operating status
9 Set up and connect the unit
CAUTION
Heavy loads (applies to unit sizes Elmasonic Select 500/900)!
Serious injuries to the spine or back muscles.
Ø Comply with the health and safety requirements on lifting heavy loads.
9.1 Notes on installation site
The unit is designed to be set up in commercially used premises such as laboratories, workshops, etc.
• The installation site must be well ventilated.
• The permissible ambient conditions are met.