Elma Elmasonic Select - Selecting Ultrasound Modes; Using Auto-Degassing; Temperature-Controlled Start

Elma Schmidbauer GmbH 12 Operating the unit
Elmasonic Select 23 / 32
To switch the heating off, press the Minus button until - - flashes on the display. The
Heating symbol disappears from the display when the heating is switched off.
12.5 Set the ultrasound mode
Degas, eco, sweep, pulse or dyn (dynamic)
Press the Mode button to set the ultrasound mode. Press the button repeatedly until
the required ultrasound mode is shown on the display.
12.6 Set auto-degas
Use this function to degas a fresh batch of cleaning fluid.
One of the ultrasound modes eco, sweep, pulse or dyn has been set.
The unit is not currently in ultrasound operation.
Hold down the Mode button until the ultrasound mode degas flashes on the display.
Press the Start/stop button to start the auto-degas function.
Alternatively, save auto-degas as a programme. See the section Save programmes
[}24] for more information.
Degas flashes slowly on the display (degassing takes approx. 10min.). Once auto-
degas has been completed, the set ultrasonic cleaning mode will start and be shown on
the display.
12.7 Set Temperature-controlled start
Use this function to start ultrasound operation automatically once the target temperature has been
reached.
IMPORTANT When cleaning sensitive objects, please note that the ultrasound is switched on briefly
multiple times during the heating phase.
The required target temperature has been set.
Ensure that the required target temperature is higher than the current actual temperature. If not,
allow the fluid to cool.
The unit is not currently in ultrasound operation.
Hold down the Start/stop button until the Temperature-controlled start symbol flashes
on the display.
Press the Start/stop button again to start the unit using the temperature-controlled
start function.
See the Save programmes section for information on saving the Temperature-
controlled start function as a programme.
The display shows the Temperature-controlled start and Heating symbols. The display
shows the set target temperature and the current actual temperature of the cleaning
fluid flashing alternately.
During the heating phase, the ultrasound is switched on briefly multiple times to ensure
that the fluid is heated evenly.
The ultrasonic cleaning function will start once the set target temperature has been
reached. The Temperature-controlled start symbol will disappear.