Elna International Corps. SA 3210 / 3230 Service manual
PRESSER BAR HEIGHT AND ALIGNMENT
To check:
When the presser foot is raised, the clearance between the presser foot and the needle plate should
be 6.0 mm.
When the presser foot is lowered, Th edge of Th foot and Th feed dog Windows on Th needle plate
should be parallel.
Adjustment procedure:
1. Remove the face cover (see page 4).
2. Raise the presser foot lifter A and loosen the screw B.
3. Adjust the distance between the presser foot C and the needle plate D to 6 mm.
4. Tighten the screw B securely.
5. Attach the face cover.
Note: When tighten the screw B, make sure that both sides of the presser foot are parallel to the
feed dog windows on the needle plate D.
Page 09
To Next Page
Loading...
