ELNEC s. r. o.
Run the control program
In Windows environment: double click to icon PG4UW.
After start, control program PG4UW automatically scan all
existing ports and search for the connected any ELNEC's
programmer. Program PG4UW is common for all the ELNEC's
programmers, hence program try to find all supported (JetProg,
BeeProg, LabProg+, SmartProg, PREPROM-02aLV,
MEMprog, T51prog, 51&AVRprog, PIKprog+, PIKprog and
SEEprog) programmers.
Notes: When PG4UW is started, program is checked for its
integrity. Than the program display a standard user menu and
waits for your instructions.
If the control program cannot communicate with the
programmer, an error message appears on the screen,
including error code and description of possible reasons
(disconnected programmer, bad connection, power supply
failure, incompatible printer port, ...). Eliminate the error source
and press any key. If error condition still exists, the program
resumes its operation in the demo mode and access to the
programmer is not possible. If you cannot find the cause of the
error, follow the instructions in Troubleshooting section. In
addition, the control program checks communication with
programmer prior to any operation with the programmed
device.
112
To Next Page
Loading...