JetProg
JetProg has 48 powerful pindrivers in base unit, expandable
up to 256 pindrivers using "pindriver expansion" modules.
Advanced pin drivers incorporate high-quality high-speed
circuitry to deliver programming and testing performance
without overshoot or ground bounce for all device
technologies. Pin drivers operate down to 1.8V so you'll be
ready to program the full range of today's advanced low-
voltage devices.
Modular design of JetProg allows adapting the programmer
according to customers needs either as very flexible universal
programmer for laboratory or high efficient multiprogrammer in
production line. Multiprogramming capability for most of
supported devices is accomplished by using "multiple socket"
modules.
Powerful pindriver provides logic level, pull-up/pull-down, clock,
ground, one VCC supply and two programming supply and,
certainly read, on each of all 48 pins independently. This
advanced design give it the ability to program almost every
programmable device in DIL up to 48 pins without adapter or
family specific module. Support for today and tomorrow
programmable devices gives engineers the freedom to choose
the optimum device for new design.
JetProg isn't only programmer, but also tester of TTL/CMOS
logic ICs and memories. Furthermore, it allows generate of
user-definable test pattern sequences.
The programmer has on-board intelligence, comprise of
powerful microcontroller system and support devices. JetProg
has been designed for multitasking operating systems and
is able to perform time-critical programming sequences
independently of the PC operating system status and without
being interrupted by any another parallel process running on
the PC. Consequently, JetProg works without any problem on
systems running Windows 95/98/Me/NT/2000/XP.
The programmer performs device insertion test (wrong or
backward position) and contact check (poor contact pin-to-
socket) before it programs each device. These capabilities,
supported by overcurrent protection and signature-byte check
help prevent chip damage due to operator error.
Built-in protection circuits eliminate damage of programmed
device due to mains supply fluctuations, communication error
or if PC is frozen. In event of such errors microcontroller in
programmer performs, independently on the PC, exactly
specified sequence of steps, so that programmed target device
remains intact. Programmer's hardware offers enough
resources for selftest, that control program is any time be able
to check pindrivers, present and correct level of all voltages,
17
To Next Page
Loading...