MagTek Device Drivers for Windows
70
model is the full name of the device model to be added. The name should be
enclosed in quotes if it contains spaces. Use "
mtcfg -models" to see a
list of models. The model names used by MTCFG are the ones specified in
the [Models] section of the MTD installation script (OEMSETUP.INF).
settings specifies one or more device settings in the form name=value. The syntax
for these is identical to the syntax used when modifying the settings of an
already installed device. See the next section for a list of common settings.
Specifying any settings when adding a device is optional−they can always
be specified later (see the next section), but it is recommended to include
at least those settings that are required for the device to operate, e.g.,
UsePort for serial devices.
To Next Page
Loading...
