MES53xx, MES33xx, MES23xx Ethernet Switch Series 112
Global configuration mode commands
Command line prompt in the global configuration mode is as follows:
console(config)#
Table 5.101. Global configuration mode commands
ipv6 mld snooping [vlan
vlan_id]
vlan_id: (1..4094).
-/disabled
no ipv6 mld snooping [vlan
vlan_id]
ipv6 mld snooping vlan
vlan_id static
ipv6_multicast_address
[interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group}]
vlan_id: (1..4094);
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16).
Register a multicast IPv6 address in the multicast addressing
table and statically add/remove interfaces from the group
for the current VLAN.
- ipv6_multicast_address - multicast IPv6 address;
Interfaces must be separated by “–” and “,”.
no ipv6 mld snooping vlan
vlan_id static
ipv6_multicast_address
[interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group}]
Remove a multicast IP address from the table.
ipv6 mld snooping vlan
vlan_id forbidden mrouter
interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group}
vlan_id: (1..4094);
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16).
Add a rule that prohibits registration of listed ports as MLD
mrouter.
no ipv6 mld snooping vlan
vlan_id forbidden mrouter
interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group}
Remove the rule that prohibits registration of listed ports as
MLD mrouter.
ipv6 mld snooping vlan
vlan_id mrouter learn
vlan_id: (1..4094).
-/enabled
Learn the ports connected to the mrouter by MLD-query
packets.
no ipv6 mld snooping vlan
vlan_id mrouter learn
Do not learn the ports connected to the mrouter by MLD-
query packets.
ipv6 mld snooping vlan
vlan_id mrouter interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group}
vlan_id: (1..4094);
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16).
Add a list of mrouter ports.
no ipv6 mld snooping vlan
vlan_id mrouter interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group}
Ipv6 mld snooping vlan
vlan_id immediate-leave
vlan_id: (1..4094)
-/disabled
Enable MLD Snooping Immediate-Leave process for the
current VLAN.