ELTEX MES53xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 113
no ipv6 mld snooping vlan
vlan_id immediate-leave
Disable MLD Snooping Immediate-Leave process for the
current VLAN.
ipv6 mld snooping querier
-/disabled
Enable igmp-query requests.
no ipv6 mld snooping querier
Disable igmp-query requests.
Ethernet, port group or VLAN interface (interface range) configuration mode commands
Command line prompt in the Ethernet, port group or VLAN interface configuration mode is as
follows:
console(config-if)#
Table 5.102. Ethernet interface (interface range), port group or VLAN interface configuration mode
commands
Command
Value/Default value
Action
ipv6 mld
-interval
interval
interval: (100..25500)/1000
ms
Specify the maximum response delay of the last group
participant that will be used to calculate the maximum
response delay code (Max Response Code).
no ipv6 mld
-interval
Restore the default value.

value
value: (30..18000)/125
seconds
Specify the interval for sending basic MLD queries.
no ipv6 mld query-interval
Restore the default value.
ipv6 mld
-time
value
value: (5..20)/10 seconds
Specify the maximum response delay that will be used to
calculate the maximum response delay code.
no ipv6 mld query-
-time
Restore the default value.
ipv6 mld robustness value
value: (1..7)/2
Specify the robustness value. If data loss occurs in the link,
the robustness value should be increased.
no ipv6 mld robustness
Restore the default value.
ipv6 mld version version
Version: (1..2)/2
Specify the protocol version operating on the current
interface.
no ipv6 mld version
Restore the default value.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#
Table 5.103. EXEC mode commands
Command
Value/Default value
Action
show ipv6 mld snooping
groups [vlan vlan_id]
[address
ipv6_multicast_address]
[source ipv6 _address]
vlan_id: (1..4094)
Show information about the registered groups according to
filter parameters defined in the command.
- ipv6_multicast_address - multicast IPv6 address;
- ipv6_address - source IPv6 address;
show ipv6 mld snooping
interface vlan_id
vlan_id: (1..4094)
Show information about MLD snooping configuration for the
current VLAN.
show ipv6 mld snooping
mrouter [interface vlan_id]
vlan_id: (1..4094)
Show information about the mrouter ports.
7.2.4 Multicast-traffic restriction
Multicast-traffic restriction is used to comfortably configure restriction for viewing the specific
multicast groups.
Commands of the global configuration mode

ELTEX MES53xx Specifications

General

Brand	ELTEX
Model	MES53xx
Category	Switch
Language	English