ELTEX MES53xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 192
Enable RIP for subnetwork 172.16.23.0 (IP address on switch 172.16.23.1) and MD5 authentication
via mykeys set of keys:
console#
console# configure
console(config)# router rip
console(config-rip)# network 172.16.23.1
console(config-rip)# interface ip 172.16.23.1
console(config-if)# ip rip authentication mode md5
console(config-if)# ip rip authentication key-chain mykeys
11.6.3 OSPF and OSPFv3 configuration
OSPF (Open Shortest Path First) — dynamic routing protocol that is based on a link-state technology
and uses Dijkstra's algorithm to find the shortest route. OSPF protocol is a protocol of an internal gateway
(IGP). OSPF protocol distributes information on available routes between routers in a single autonomous
system.
The device supports multiple independent instances of OSPF processes operating simultaneously.
An OSPF instance is configured by specifying its ID (process_id).
Global configuration mode commands
Command line prompt in the global configuration mode is as follows:
console(config)#
Table 5.228. Global configuration mode commands
Command
Value/Default value
Action
router ospf [process_id]
process_id: (1..65535)/1
Enable routing via OSPF.
Specify the process ID.
no router ospf [process_id]
Disable routing via OSPF.
ipv6 router ospf
[process_id]
process_id: (1..65535)/1
Enable routing via OSPFv3 protocol.
Specify the process ID.
no ipv6 router ospf
[process_id]
Disable routing via OSPFv3 protocol.
ipv6 distance ospf
 | intra-as}
distance
distance: (1..255)
Set administrative distance for OSPF and OSPFv3 routes.
-inter-as - for external autonomous systems
-intra-as - inside an autonomous system
no ipv6 distance ospf
{inter-as |intra-as}
Return default values.
OSPF process mode commands
Command line request in the OSPF process configuration mode:
console(router_ospf_process)#
console(ipv6 router_ospf_process)#
Table 5.229. OSPF process configuration mode commands
Command
Value/Default value
Action
redistribute connected
[metric metric] [route-map
name ] [subnets]
metric: (1..65535);
name: (1..255) characters
Allow announcing of connected routes:
- metric - a metric for imported routes;
- name - the name of the import policy that allows filtering
and changes in imported routes;
- subnets - allows you to import subnetworks.
no redistribute connected
[metric metric] [route-map
name] [subnets]
Disable a specific function

ELTEX MES53xx Specifications

General

Brand	ELTEX
Model	MES53xx
Category	Switch
Language	English