EasyManua.ls Logo

ELTEX MES53xx

ELTEX MES53xx
208 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MES53xx, MES33xx, MES23xx Ethernet Switch Series 193
metric: (1..65535);
name: (1..255) characters
Import static routes to OSPF.
- metric - set the metric for imported routes;
- name - apply the import policy that allows filtering and
changes in imported routes;
- subnets - allows you to import subnetworks.
Disable a specific function.
id: (1..65535);
metric: (1..65535);
name: (0..32) characters.
Import routes from one OSPF process to another OSPF
process:
- nssa-only - set the value of nssa-only for all imported
routes;
- metric-type type-1 import with a stamp 'OSPF external
1';
- metric-type type-2 import with a stamp 'OSPF external 2';
- match internal - import routes within an area;
- match external-1 - import routes of the 'OSPF external 1'
type;
- match external-2 - import routes of the 'OSPF external 2'
type;
- subnets - import subnetworks;
- name - apply the specified import policy that allows
filtering and changes in imported routes;
- metric - set the metric for imported routes.
Disable a specific function.
metric: (1..65535);
name: (1..255) characters.
Import routes from RIP to OSPF.
- metric - a metric for imported routes;
- name - the name of the import policy that allows filtering
and changes in imported routes;
- subnets - allows you to import subnetworks.
Disable a specific function.
-/enabled
Enable compatibility with RFC 1583 (for IPv4 only)
Disable compatibility with RFC 1583.
A.B.C.D: router ID in the
IPv4 address format
Assign router ID that uniquely identifies the router within an
autonomous system.
Set the default value.
ip_addr: A.B.C.D
Enable (disable) an instance of OSPF on the IP interface (for
IPv4).
Delete the IP address of the interface.
metric: (1..65535)
Set the metric for an OSPF route.
Disable the function.
A.B.C.D: router ID in the
IPv4 address format
Set the “stub” type for the specified area. An area is a set of
networks and routers that have the same ID.
- no-summary - do not send information about external
summary routes.
Set the default value.

Table of Contents

Related product manuals