ELTEX MES53xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 175
show access-lists

[access_list]
characters.
Display active ACLs created on a switch.
show interfaces access-lists
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group |
vlan vlan_id]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094).
Displays ACLs assigned to interfaces.
clear access-lists counters
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group |
vlan vlan_id]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094).
Reset all ACL counters or ACL counters for the specified
interface.
show interfaces access-lists
trapped packets
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group |
vlan vlan_id]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094).
Display ACL counters.
EXEC mode commands
Command line in the EXEC mode appears as follows:
console#
Table 5.203. ACL display commands
Command
Value/Default value
Action
show time-range
[time_name]
-
Display the time-range configuration.
11.3.1 IPv4-based ACL Configuration
This section provides description of main parameters and their values for IPv4-based ACL
configuration commands. In order to create an IPv4-based ACL and enter its configuration mode, use the
following command: ip access-list extended access-list. For example, to create an ACL
named EltexAL, execute the following command:
console#
console# configure
console(config)# ip access-list extended EltexAL
console(config-ip-al)#
Table 5.204. Main command parameters
Parameter
Value
Action
permit
Permit action
Create a ‘permit’ filtering rule in the ACL.
deny
Deny action
Create a ‘deny’ filtering rule in the ACL.
protocol
Protocol
This field is used to specify the protocol value (or all protocols)
which will be used to filter traffic. The following protocol
values are available: icmp, igmp, ip, tcp, egp, igp, udp, hmp,
rdp, idpr, ipv6, ipv6:rout, ipv6:frag, idrp, rsvp, gre, esp, ah,
ipv6:icmp, eigrp, ospf, ipinip, pim, l2tp, isis, ipip, or the
numeric value of the protocol number (0–255).
To match all protocols, specify the value ip.

ELTEX MES53xx Specifications

General

Brand	ELTEX
Model	MES53xx
Category	Switch
Language	English