112 SBC session border controllers
4.2.7.4 Dynamic firewall parameters configuration mode
To enter this mode, execute firewall dynamic command in the configuration mode.
SBC-[CONFIG]> firewall dynamic
Entering dynamic firewall mode.
SBC-[CONFIG]-[DYN-FIREWALL]>
Show the list of available commands.
IP address in
AAA.BBB.CCC.DDD
format or subnet
in CIDR
AAA.BBB.CCC.DDD/FF
notation
Add an address to the list of blocked addresses
IP address in
AAA.BBB.CCC.DDD
format or subnet
in CIDR
AAA.BBB.CCC.DDD/FF
notation
Remove an address to the list of blocked addresses
Remove an address to the list of blocked addresses by
its position in the list
Show the list of blocked addresses
Show the number of entries in the list of addresses
blocked by the dynamic firewall
IP address in
AAA.BBB.CCC.DDD
format or subnet
in CIDR
AAA.BBB.CCC.DDD/FF
notation
Find the specified address in the list of blocked
addresses
Show the specified number from the beginning of the
list of blocked addresses
Show the specified number from the end of the list of
blocked addresses
Show the entry in the specified position of the list of
blocked addresses
subnet in CIDR
AAA.BBB.CCC.DDD/FF
notation
Add a subnet to the list of blocked addresses and
remove addresses and subnets included in the added
subnet
View a log of blocked addresses
Show the number of entries in the log of blocked
addresses
IP address in
AAA.BBB.CCC.DDD
format or subnet
in CIDR
AAA.BBB.CCC.DDD/FF
notation
Find the specified address in the log of blocked
addresses
Show the specified number from the beginning of the
log of blocked addresses
Show the specified number from the end of the log of
blocked addresses
Show the entry in the specified position of the log of
blocked addresses
IP address in
AAA.BBB.CCC.DDD
format or subnet
in CIDR
AAA.BBB.CCC.DDD/FF
notation
Remove an address to the list of automatically blocked
addresses
Remove an address to the list of automatically blocked
addresses by its position in the list