ELTEX SBC-1000 - Page 118

118 SBC session border controllers
<ACTION>
<P_IDX>
timestamp-request
timestamp-reply
address-mask-request
address-mask-reply
accept, drop, reject
1-65535
Action — action executed by this rule:
– ACCEPT — packets falling under this rule will
be accepted by the firewall;
– DROP — packets falling under this rule will
be rejected by the firewall without informing
the party that has sent these packets;
– DROP — packets falling under this rule will
be rejected by the firewall; the party that has
sent the packet will receive either TCP RST
packet or 'ICMP destination unreachable'.
Firewall profile number
apply
Apply firewall settings
config
Return to Configuration menu.
del profile
<ID>
1-65535
Remove firewall profile
del rule
<ID>
1-65535
Remove firewall rule
exit
Exit from this configuration submenu to the
upper level.
modify profile
<ID>
<NAME>
1-65535
allowed using
letters, numbers,
character'_'. 63
characters max.
Firewall profile index
Enter a new name for the device
modify rule
<TYPE>
<ID>
<param>
action
dport_end
dport_start enable
icmp-type
name
prof_id
proto
r_ip r_mask
s_ip s_mask
sport_end
sport_start
traffic-type
1-65535
New value according
to this parameter
type
Modify the firewall rule specified (one of the
parameters)
move down
<ID>
1-65535
Move the rule one position down
move up
<ID>
1-65535
Move the rule one position up
quit
Terminate this CLI session
set interface
<IFACE_NAME>
<PROFILE ID>
Interface name
Assign the rule to the network interface
PROFILE ID = 0 means that profile will not
be used
show config
Show configuration
show net-
interfaces
Show interface parameters:
show system
Show system parameters