ELTEX SBC-1000 - Page 121

SBC session border controllers 121
set interface ssh
<NET_IFACE_IDX>
<ON_OFF>
0-39
on/off
Allow ssh session via interface
set interface
telnet
<NET_IFACE_IDX>
<ON_OFF>
0-39
on/off
Allow telnet session via interface
set interface
use_mppe
<NET_IFACE_IDX>
<ON_OFF>
0-39
on/off
Enable/disable encryption (VPN interface only)
set interface
user_name
<NET_IFACE_IDX>
<USER>
0-39
you may use letters,
numbers, '_', '.', '-'
characters, 63
characters max.
Set user name (VPN interface only)
set interface
user_pass
<NET_IFACE_IDX>
<PASS>
0-39
you may use letters,
numbers, '_', '.', '-'
characters, 63
characters max.
Set password (VPN interface only)
set interface VID
<NET_IFACE_IDX>
<VID>
0-39
1-4095
Assign VID for the interface
set interface web
<NET_IFACE_IDX>
<ON_OFF>
0-39
on/off
Allow the access via web interface
set settings dns
primary
<IPADDR>
IP address in
AAA.BBB.CCC.DDD format
Set main DNS server IP address
set settings dns
secondary
<IPADDR>
IP address in
AAA.BBB.CCC.DDD format
Set redundant DNS server IP address
set settings
gateway_iface
<NET_IFACE_NAME>
Name of the interface whose gateway will be
the default gateway
set settings
hostname
<HOSTNAME>
you may use letters,
numbers, '_', '.', '-'
characters, 63
characters max.
Set the host name
set settings ssh
<PORT>
1-65535
Set the TCP port for SSH access to the device,
the default is 22
set settings
telnet
<PORT>
1-65535
Set the TCP port for Telnet access to the device,
the default is 23
set settings web
<PORT>
1-65535
Set the TCP port for web configurator, default is
80
show interface
by_index
<NET_IFACE_IDX>
0-39
Show the settings of the specified network
interface
show interface
list
Show the list of available network interfaces
show settings
Show network parameters
snmp
Enter the SNMP configuration mode
ssh restart
SSH restart process
4.2.7.8 NTP configuration mode
To enter this mode, execute ntp command in the network parameters configuration mode.
SBC-[CONFIG]-NETWORK> ntp
Entering NTP mode.
SBC-[CONFIG]-[NETWORK]-NTP>
Command
Parameter
Value
Action
?
Show the list of available commands.
apply
no/yes
Apply NTP settings
config
Return to Configuration menu.
exit
Exit from this configuration submenu to the
upper level.
quit
Terminate this CLI session