ELTEX SBC-1000 - Page 126

126 SBC session border controllers
<ENABLE>
disable/enable
IFACE_NAME — network interface
ENABLE — enable/disable network route
route del
<IDX>
0-4095
Delete route:
IDX — network route index
route modify
destination
<IDX>
<DESTINATION>
0-4095
Change the destination address
route modify
dev
<IDX>
<IFACE_NAME>
0-4095
network interface
name
Change the network interface
route modify
enable
<IDX>
<EN>
0-4095
enable/disable
Enable or disable the route
route modify
gateway
<IDX>
<GATEWAY>
0-4095
IP address in
AAA.BBB.CCC.DDD
format
Change the gateway
route modify
metric
<IDX>
<METRIC>
0-4095
0-2147483647
Change the metric
route modify
netmask
<IDX>
<NETMASK>
0-4095
mask in format of
AAA.BBB.CCC.DDD
Change network mask
route modify
vpn-client
<IDX>
<VPN_CLIENT>
0-4095
VPN client name
Change VPN client
route VPN add
<DESTINATION>
<MASK>
<METRIC>
<VPN_CLIENT>
<ENABLE>
IP address in
AAA.BBB.CCC.DDD
format
mask in format of
AAA.BBB.CCC.DDD
unsigned integer
string, 255
characters max.
disable/enable
Add a route via VPN client:
DESTINATION — IP address of the
destination;
MASK — network mask for the specified IP
address;
METRIC — metric
VPN_CLIENT — VPN client name
ENABLE — enable/disable network route
show config
Show information on route configuration
show net-
interfaces
Show the list of network interfaces
show system
Show active routes
show vpn-
clients
Show list of VPN clients
4.2.7.14 Configuring a list of rule sets
To enter this mode, execute 'rule set' command in the configuration mode.
SBC1000-[CONFIG]> rule set
Entering SBC rule set mode.
SBC1000-[CONFIG]-RULE-SET>
Command
Parameter
Value
Action
?
Show the list of available commands.
add rule set
SBC_RULE_SET_NAME
String, 63
characters max.
Add the rule set