ELTEX SBC-1000 - Page 125

SBC session border controllers 125
trunk — use the name of the trunk over
which the incoming connection is made as
a value
config
Return to Configuration menu.
exit
Exit from this configuration submenu to
the upper level.
history
View history of entered commands.
name
<PRF_NAME>
String, 63 characters
max.
Set profile name
quit
Terminate this CLI session
show
Show RADIUS profile configuration
4.2.7.12 Reserve operation mode
To enter this mode, execute 'reserve' command in the configuration mode.
SBC1000-[CONFIG]> reserve
Entering reserve mode.
SBC1000-[CONFIG]-[RESERVE]>
Command
Parameter
Value
Action
?
Show the list of available commands.
config
Return to Configuration menu.
exit
Exit from this configuration submenu to the
upper level.
history
View history of entered commands.
set master
SERIAL_NUMBER
String, 10 characters
Make the device with the specified serial
number a master
show
Show reserve status information
quit
Terminate this CLI session
show
Show RADIUS profile configuration
4.2.7.13 Static route configuration mode
To enter this mode, execute 'route' command in the configuration mode.
SBC-[CONFIG]> route
Entering route mode.
SBC-[CONFIG]-ROUTE>
Command
Parameter
Value
Action
?
Show the list of available commands.
config
Return to Configuration menu.
exit
Exit from this configuration submenu to the
upper level.
history
View history of entered commands.
quit
Terminate this CLI session
route default
add
<DESTINATION>
<MASK>
<GATEWAY>
<METRIC>
<IFACE_NAME>
IP address in
AAA.BBB.CCC.DDD
format
mask in format of
AAA.BBB.CCC.DDD
gateway in format of
AAA.BBB.CCC.DDD
unsigned integer
string, 255
characters max.
Add static route:
DESTINATION — IP address of the
destination;
MASK — network mask for the specified IP
address;
GATEWAY — gateway IP address;
METRIC — metric