ELTEX SBC-1000 - Page 124

124 SBC session border controllers
SBC-[CONFIG]-RADIUS> profile 0
Entering RADIUS-Profile-mode.
SBC-[CONFIG]-RADIUS-PROFILE[0]>
Command
Parameter
Value
Action
?
Show the list of available commands.
auth
digestauth
<DIGESTAUTH>
rfc5090/
rfc5090-no-challenge/
draft-sterman
Select the algorithm of subscriber
authorization with dynamic registration
through the RADIUS server. With digest
authentication, the password is
transmitted as a hash code and cannot be
intercepted when traffic is scanned
auth
framedprotocol
<FRAMED_PROTOCOL>
none/PPP/
SLIP/ARAP/
Gandalf/Xylogics/
X75_Sync
Assign a protocol when using packet access
for RADIUS authentication requests
none — packet access is not used
auth nas port
type
<PORT_TYPE>
Async/
Sync/
ISDN_Sync/
ISDN_Async_v120/
ISDN_Async_v110/
Virtual/
PIAFS/
HDLC_Channel/
X25/
X75/
G3_Fax/
SDSL/
ADSL_CAP/
ADSL_DMT/
IDSL/
Ethernet/
xDSL/
Cable/
Wireless/
Wireless_IEEE_802.1
Assign the type of the physical NAS port
(the server where the user is
authenticated), Async is default
auth restrict
<RESTRICT>
none/
restrict-all
Set a limit on outgoing communication
when the server fails (no response from
the server):
none — allow all calls;
restrict-all — restrict all calls
auth service
type
<SERVICE_TYPE>
none/
Login/
Framed/
Callback_Login/
Callback_Framed/
Outbound/
Administrative/
NAS_Promt/
Authenticate_Only/
Callback_NAS_Prompt/
Call_Check/
Callback_Administrative
Set the type of service, by default it is none
auth user_name
originate
<USERNAME_MODE>
sip_username/
ip/
sip_iface_name
Set the User-Name attribute in Access-
Request packages:
cgpn — use the telephone number of the
calling party as the value;
ip_or_stream — use the IP address of the
calling party or the number of the stream
on which the incoming connection is made
as the value;