ELTEX SBC-1000 - Page 123

SBC session border controllers 123
modify type
<IDX>
<TYPE>
0-15
trapsink/
trap2sink/
informsink
Change the SNMP trap transmission rule (SNMP
message type)
quit
Terminate this CLI session
remove
<IDX>
0-15
Remove SNMP trap transmission rule
restart snmpd
Yes/no
Restart SNMP client
ro
<RO>
string, 63
characters max.
Set the password for reading the parameters
rw
<RW>
string, 63
characters max.
Set the password for reading and recording the
parameters
show
Show SNMP configuration
syscontact
<SYSCONTACT>
string, 63
characters max.
Specify contact information
syslocation
<SYSLOC>
string, 63
characters max.
Specify device location
sysname
<SYSNAME>
string, 63
characters max.
Specify device name
4.2.7.10 Radius configuration mode
To enter this mode, execute radius command in the configuration mode.
SBC-[CONFIG]> radius
Entering RADIUS mode.
SBC-[CONFIG]-RADIUS>
Command
Parameter
Value
Action
?
Show the list of available commands.
auth ipaddr
<IP_ADDR>
<SRV_IDX>
IP address in
AAA.BBB.CCC.DDD
format
0-8
Set authorization server IP address.
IP_ADDR — IP address;
SRV_IDX — server number
auth port
<PORT>
<SRV_IDX>
0-65535
0-8
Set authorization server port
PORT — port number;
SRV_IDX — server number
auth secret
<SECRET>
<SRV_IDX>
string, 31
characters max.
0-8
Set the password for authorization server
SECRET — password;
SRV_IDX — server number
config
Return to Configuration menu.
deadtime
<DEADTIME>
5-60
Server downtime in case of failure — time during
which the server is considered inactive
exit
Exit from this configuration submenu to the upper
level.
history
View history of entered commands.
profile
<PROFILE_INDEX>
0-31
Go to the RADIUS profile parameters configuration
quit
Terminate this CLI session
retries
<RETRIES>
2-5
Set the number of attempts to send a request
show config
Show information on RADIUS server configuration
timeout
<TIMEOUT>
3-10
Set the time for which the server is expected to
respond (x100ms)
4.2.7.11 RADIUS profile parameters configuration mode
To enter this mode, in the RADIUS configuration mode, run the profile <PROFILE_INDEX> command,
where <PROFILE_INDEX> is the RADIUS profile number.