ELTEX SBC-1000 - Page 133

SBC session border controllers 133
4.2.7.21 SIP users configuration
To enter this mode, in the SIP destination list configuration mode, execute the edit user <ID>
or edit user index <INDEX> command, where <ID> and <INDEX> — ID or index of the edited user.
SBC1000-[CONFIG]-SIP-USERS> edit user id 1
Entering SBC SIP user edit mode.
SBC1000-[CONFIG]-SIP-USER-ID[1]>
SBC1000-[CONFIG]-SIP-USERS> edit user index 0
Entering SBC SIP user edit mode.
SBC1000-[CONFIG]-SIP-USER-INDEX[0]>
Command
Parameter
Value
Action
?
Show the list of available commands.
exit
Exit from this configuration submenu to
the upper level.
quit
Terminate this CLI session
set allow
redirection
ON_OFF
on/off
Management of permissions for
handling redirects
set command line
CMDLINE
String
Set the advanced SIP settings rules
set convert
flash
ON_OFF
on/off
Enable or disable conversion of Flash
from RFC2833 to SIP INFO
set name
SIP_USER_NAME
String, 63
characters max.
Set SIP user name
set nat keep-
alive
KEEP_ALIVE
0-65535
Connection behind NAT storage time,
sec
set nat
subscribers
ON_OFF
on/off
Enables «subscriber behind NAT» mode
set preserve
contact header
ON_OFF
on/off
Enable unchanged contact transmission
set radius
profile id
RADIUS_PROFILE_ID
1-65535
Assign RADIUS profile
set radius
profile none
Unassign RADIUS profile
set registration
interval
REG_INTERVAL
60-65535
Set the permissible re-registration
interval for users, sec
set restrictions
non-registered
deny-all
Set call restriction for unregistered
users — everything is restricted
set restrictions
non-registered
maximum-sessions
MAXIMUM_SESSIONS
1-65535
Set call restriction for unregistered
users — maximum session number
set restrictions
non-registered
no-restriction
Set call restriction for unregistered
users — no restriction
set restrictions
registered deny-
all
Set call restriction for registered users
— everything is restricted
set restrictions
registered
maximum-sessions
MAXIMUM_SESSIONS
1-65535
Set call restriction for registered users
— maximum session number
set restrictions
registered no-
restriction
Set call restriction for registered users
— no restriction
set rtcp timeout
TIMEOUT
10-300/off
Set the RTCP waiting timeout from the
counterparty.
off — disable RTCP waiting.
set rtp-loss
timeout
TIMEOUT
10-300/off
Set the RTP waiting timeout from the
counterparty.
off — disable RTP waiting.
set rtp-loss
multiplier on
hold
TIMEOUT_MULTIPLIER
1-30
Set the RTP waiting multiplier in the on
hold mode.