150 SBC session border controllers
Syntax
speed auto
Parameters
Command contains no arguments.
Example
SBC2000-[CONFIG]-[SWITCH]-[if]> speed auto
The speed for the port will be set automatically.
show interfaces configuration
This command is used to view the configuration of the SBC-2000 switch interfaces
Syntax
show interfaces configuration <interface> <number>
Parameters
<interface> — interface type:
front-port — external uplink interfaces;
host-channel;
host-port;
port-channel — external LAG uplink interface aggregation groups;
sm-port.
<number> — port number:
all — all ports of the selected interface;
for front port: <unit/port>, where:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 3];
for host-channel: [1];
for host-port:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 2];
for port-channel: [0 .. 4].
for sm-port: [0 .. 15].
unit — module number, may take value [1],
port — port number, may take values: [0 .. 5].
Example
SBC2000-[CONFIG]-[SWITCH]> show interfaces configuration front-port all
Port Duplex Speed Neg Flow Admin
control State
------------------ ------ -------- -------- ------- -----
front-port 1/0 Full 10 Mbps Enabled Off Up
front-port 1/1 Full 10 Mbps Disabled Off Up
front-port 1/2 Full 10 Mbps Enabled Off Up
front-port 1/3 Full 10 Mbps Enabled Off Up
SBC2000-[CONFIG]-[SWITCH]>
To Next Page
Loading...