SBC session border controllers 151
show interfaces status
This command allows viewing information about the status of an interface, a group of interfaces.
Syntax
show interfaces status <interface> <number>
Parameters
<interface> — interface type:
front-port — external uplink interfaces;
host-channel
host-port ;
port-channel — external LAG uplink interface aggregation groups;
sm-port
<number> — port number:
all — all ports of the selected interface;
for front port: <unit/port>, where:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 3];
for host-channel: [1];
for host-port:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 2];
for port-channel: [0 .. 4].
for sm-port:
unit — module number, may take value [1],
port — port number, may take values: [0 .. 5].
Example
SBC2000-[CONFIG]-[SWITCH]> show interfaces status front-port all
Port Media Duplex Speed Neg Flow Link Back
control State Pressure
------------------ ------- ------ -------- -------- ------- ----- --------
front-port 1/0 N/A N/A N/A N/A N/A Down N/A
front-port 1/1 copper Full 10 Mbps Disabled Off Up Disabled
front-port 1/2 copper Full 100 Mbps Enabled Off Up Disabled
front-port 1/3 N/A N/A N/A N/A N/A Down N/A
SBC2000-[CONFIG]-[SWITCH]>
show interfaces counters
This command allows viewing the counters of an interface or group of interfaces.
Syntax
show interfaces counters <interface> <number>
To Next Page
Loading...