SBC session border controllers 79
The «Start» and «Stop» buttons are used to control the PPTP server. When stopped, new client connections
will not be created, but those already created will continue to work. Server status information is updated by clicking
the «Update» button next to the header.
4.1.5.4 L2TP server
Network services –> L2TP server
L2TP server settings
– Enabled — start the service at startup/reboot;
– Server address — IP address that will be
reported as the server address to all connecting
L2TP clients;
– First client address, Last client address — range
of IP addresses assigned to L2TP clients;
– Network interface — select the interface to
connect to the L2TP server;
– Port — number of port used for connection;
– DNS server — address of the DNS server, which
will be reported to clients;
– One tunnel for one host — limit the number of
tunnels to one per host;
– Use length bit in l2tp packets — using the length
bit represented in the L2TP packet load;
– Use hidden AVP — use of hidden AVPs (more
details in RFC 2661);
– Enable Web, Enable Telnet, Enable SSH — the
availability of the corresponding management
service at the specified address;
– Enable SNMP, Enable RADIUS — flag to enable
the corresponding client at the specified
address.
Server status information is updated by clicking
the «Update» button next to the header.
4.1.5.5 VPN/PPTP/L2TP users
Network services –> L2TP server
This table shows a list of VPN/PPTP/L2TP clients that are
allowed to connect to this server.
The client can be assigned a permanent IP address from
the configured range (Client address). If 0.0.0.0.0 is set, the
client will get a free IP address from the range each time a new
connection is made.
To add a user, you need to fill the following fields:
– Username — the name with which the user will connect to the server;
– Password — the password with which the user will connect to the server;
– Client address — address to be given to the client inside the tunnel. If you
want to output the address dynamically, you must leave the field blank
or with the address 0.0.0.0.
To Next Page
Loading...