79 VoIP Subscriber Gateways
- CPC – when checked, perform a short-time break of the subscriber loop on clearback
from the opposite subscriber's side;
- CPC time (ms) - duration of short-term subscriber loop rupture (range from 200 to 3000
ms);
Supplementary services:
- Flash mode – flash function operation mode (short clearback):
Transmit flash – transmit flash into the channel using one of the methods described
in 'Profiles' tab, 'Flash transmission' parameter);
Attended calltransfer – flash dialing will be processed locally by the device (call
transfer will be performed when the connection with the third party is established).
For the 'Attended calltransfer' detailed operation algorithm see in the section 4.1;
Unattended call transfer – flash will be processed locally by the device (call transfer
will be performed when the subscriber finishes dialling a third party number). For
the Unattended call transfer detailed operation algorithm, see the section 4.1;
Local call transfer - call transmission within device, without REFER message
sending. For the Local call transfer detailed operation algorithm, see the section
4.1.
- Callwaiting – when checked, 'Call waiting' service will be enabled otherwise - disabled
(this service is available in 'flash—call transfer' function operation mode);
- Direct number – when the phone goes offhook, dial the defined number immediately;
- Hotline/warmline – when checked, 'Hotline/warm line' service is enabled. This service
allows establishing an outgoing connection automatically without dialling the number
after the phone handset is picked up with the defined delay (in seconds). When
checked, fill in the following fields:
To Next Page
Loading...
Need help?
General
