80 VoIP Subscriber Gateways
Hotline/warmline number – phone number that will be used for connection
establishment upon Delay timeout expiration after the phone handset is picked up
(in SIP profile being used, a prefix for this direction should be defined in the
numbering schedule).
Delay timeout, seconds – time interval that will be used for connection
establishment with the opposite subscriber, in seconds.
- Call forward unconditional – when selected, CFU (Call Forward Unconditional) service is
enabled—all incoming calls will be forwarded to the specified call forward unconditional
number. When checked, fill in the following fields:
Call forward unconditional number – number that all incoming calls will be
forwarded to when Call forward unconditional service is enabled (in SIP profile
being used, a prefix for this direction should be defined in the numbering schedule).
- Call forward on busy – when selected, CFB (Call Forward on Busy) service is enabled—
forward the call to the specified number, when the subscriber is busy. When checked,
fill in the following fields:
Call forward on busy number – number that all incoming calls will be forwarded to
when the subscriber is busy (in SIP profile being used, a prefix for the specific
direction should be defined in the numbering schedule).
- Call forward on no answer – when selected, CFBNA (Call Forward on no Answer) service
is enabled—forward the call when there is no answer from the subscriber. When
checked, fill in the following fields:
Call forward on no answer – number that incoming calls will be forwarded to when
there is no answer from the subscriber and Call forward on no answer service is
enabled (in SIP profile being used, a prefix for this direction should be defined in the
numbering schedule)
No answer timeout, seconds – time interval that will be used for call forwarding
when there is no answer from the subscriber, in seconds.
- Do not disturb – when selected, temporary restriction is placed for incoming calls (DND
service).
- CLIR – caller ID service restriction:
Disable – CLIR service is disabled;
SIP:From – ‘anonymous’ will be sent in the ‘From’ header of ‘SIP’ message;
SIP:From and SIP:Contact – «anonymous» will be sent in the ‘From’ and ‘Contact’
headers of SIP messages.
To Next Page
Loading...
