BioProTT
TM
Flow Measurement System Version 1.00 page 10 of 75
Direct current
(24 V DC from external power supply unit)
Caution
Further warnings and precautions exist.
(Refer to these instructions for use)
3.3 Symbols on Flow Meter, Sensors and on Packaging
Caution
Further warnings and precautions exist.
(Refer to these instructions for use)
Protected against dust and high pressure water jets / wash down from all
directions (BioProTT™ FlowTrack, BioProTT FlowTrack plus,
BioProTT™ Clamp-On Transducer).
Please note: Unused connector sockets should be covered e.g. with the
provided flexible grip caps to avoid accumulation of dirt or any
potential short circuits.
Protected against access by finger (BioProTT™ FlowTrack DINrail)
Direct current
(24 V DC from external power supply unit)
Do not dispose of this device as domestic waste!
Waste devices must be disposed of in accordance with Directive
2002/96/EEC and national legislation.
Manufacturer:
em-tec GmbH
Lerchenberg 20
86923 Finning
Germany
CE marking: The device satisfies the requirements of EMC Directive
2004/108 EC
To Next Page
Loading...